putting surface

英 [ˈpʊtɪŋ ˈsɜːfɪs]

美 [ˈpʊtɪŋ ˈsɜːrfɪs]

【体】推杆区

英英释义

noun

• an area of closely cropped grass surrounding the hole on a golf course
  1. the ball rolled across the green and into the bunker
  Synonym:greenputting green

双语例句

• For as long as I could I had been putting off writing songs for my next album because I knew once I went into this headspace it would be a while before I could surface.
  那时我可能推迟为新专辑写歌，因为我知道一旦我涉足到那里，在我浮出水面前会有一段时间。
• The last phase of construction is parsing: putting the expressions relayed from the last phase into grammatical dependencies and arranging the latter in a linear format for the surface text.
  建构的最后一个阶段必须是&分析（parsing）阶段，它会把连接起来的表达形式进一步作语法依存分析并以线性格式来表现为语篇。
• You can test eggs by putting them in water; a good egg will sink while a bad egg will rise to the surface.
  鸡蛋放入水中就可检验鸡蛋的好坏，好鸡蛋会沉入水底，而坏鸡蛋则会漂浮到水面上。
• With the rapid development of pavement traffic industry, people are putting forward higher requirements on the quality and maintenance of the pavement surface.
  随着公路交通运输业的飞速发展，人们对公路路面质量及养护提出了更高的要求。
• The MFT of image sensor is measured and calculated by putting rectangle template on the surface of image sensor and projecting rectangle template on the imaging sensor directly.
  该方法将矩形模板紧贴于图像传感器，使矩形模板直接投射到图像传感器上，从而对图像传感器MTF进行测量。
• It is reachable in two and the green is fairly exposed so you can chase a ball onto the putting surface.
  在这里，可以得到低于标准杆2杆的成绩。因为草地完全暴露所以你可以看着球在地表滚动并且追逐它也很容易。
• The noise reduction methods are reducing the vibration for dynamic systems and putting sound-absorbing material in the shell surface.
  对潜艇常用的降噪方法是给动力系统进行减振处理和在壳体表面贴吸声材料。
• Methods The vibration isolation design was achieved by putting a set of T type rubber absorbers between the model and its mounted surface.
  方法在模型与其连接面之间增加一组上下对接的T型橡胶减振器实现减振设计。
• Before putting a new ring on the frame, it is unnecessary to make any other treatment just removing the oil from the surface by wiping with a clean and soft cloth.
  新钢领上车前，只需有清洁柔软的布料揩拭表面，以去掉油脂，不需再经任何表面处理。
• Consequently, putting inlet at the surface of medium and putting outlet at the middle-upper part of the medium is advised.
  因此，建议将进水口置于湿地基质表层，而将出水口置于基质层的中上部。